28-12-2018, 09:43
(Ten post był ostatnio modyfikowany: 28-12-2018, 12:36 przez Jarewa0606.)
eps8266 niby toleruje IO 5V sporo osób na zagranicznych forach o tym tez pisze. Sam mam podłączonego ESP RS 3,3v-5V i nic się nie dzieje złego.
W specyfikacji mona takie coś przeczytać:
All digital IO pins are protected from over-voltage with a snap-back circuit connected between the
pad and ground. The snap back voltage is typically about 6V, and the holding voltage is 5.8V. This provides protection from over-voltages and ESD. The output devices are also protected from reversed voltages with diodes.
W specyfikacji mona takie coś przeczytać:
All digital IO pins are protected from over-voltage with a snap-back circuit connected between the
pad and ground. The snap back voltage is typically about 6V, and the holding voltage is 5.8V. This provides protection from over-voltages and ESD. The output devices are also protected from reversed voltages with diodes.
Arduino zostało wymyślone po to, by robić dobrze jedną prostą rzecz – migać diodą.