[luko91]

Da się to obejść ? Znalazłem wersję z takim kontruktorem:
@param lcd_Addr[in] I2C address of the IO expansion module. For I2CLCDextraIO,
the address can be configured using the on board jumpers.
@param En[in] LCD En (Enable) pin connected to the IO extender module
@param Rw[in] LCD Rw (Read/write) pin connected to the IO extender module
@param Rs[in] LCD Rs (Reset) pin connected to the IO extender module
@param d4[in] LCD data 0 pin map on IO extender module
@param d5[in] LCD data 1 pin map on IO extender module
@param d6[in] LCD data 2 pin map on IO extender module
@param d7[in] LCD data 3 pin map on IO extender module

LiquidCrystal_I2C(uint8_t lcd_Addr, uint8_t En, uint8_t Rw, uint8_t Rs, uint8_t d4, uint8_t d5, uint8_t d6, uint8_t d7, uint8_t backlighPin, t_backlighPol pol);

Pytanie jak to ustawić?