Odnośnie programowania wpisałem tylko w PDF "12V" i jest taki opis:
"The following sequence enables the Tiny Programming Interface (see Figure 15-3 for guidance):
• Apply 5V between VCC and GND
• Depending on the method of reset to be used:
– Either: wait tTOUT (see Table 17-4 on page 127) and then set the RESET pin low. This will reset the device and
enable the TPI physical layer. The RESET pin must then be kept low for the entire programming session
– Or: if the RSTDISBL configuration bit has been programmed, apply 12V to the RESET pin. The RESET pin
must be kept at 12V for the entire programming session
• Wait tRST (see Table 17-4 on page 127)
• Keep the TPIDATA pin high for 16 TPICLK cycles"
Jak to zrobiłeś na shieldzie z opisu wsadu do Arduino? Przełączasz jakoś zworkami tryb programowania "normalnego" i HV?
"The following sequence enables the Tiny Programming Interface (see Figure 15-3 for guidance):
• Apply 5V between VCC and GND
• Depending on the method of reset to be used:
– Either: wait tTOUT (see Table 17-4 on page 127) and then set the RESET pin low. This will reset the device and
enable the TPI physical layer. The RESET pin must then be kept low for the entire programming session
– Or: if the RSTDISBL configuration bit has been programmed, apply 12V to the RESET pin. The RESET pin
must be kept at 12V for the entire programming session
• Wait tRST (see Table 17-4 on page 127)
• Keep the TPIDATA pin high for 16 TPICLK cycles"
Jak to zrobiłeś na shieldzie z opisu wsadu do Arduino? Przełączasz jakoś zworkami tryb programowania "normalnego" i HV?
Miło być decenianym https://buycoffee.to/kaczakat